Monday, November 10, 2008

Tom Bugs teaches DIY synth building in four hours



Had a great time yesterday at a synth building workshop in East London hosted by Tom Bugs. We built little one board synths with ten knobs, three oscillators, overdrive, line out, onboard speakers, touch points. Flickr set here. What I learned:

1. Soldering now holds no fear. Get a £5 soldering iron with a pointy tip, a cleaning pad, some skinny solder and some wire snippers. It's fine.

2. Well-designed kits are really easy to make. Tom's kit was perfect - well laid out, nice clear circuit board, great instructions (he should be selling the kits 'soon'). The quickest maker did it in about 3 hours, and that was slow and steady... (The Thingamakit is another really well done kit which is available now)

3. Musical accompaniment is important. We were lucky enough to have the Sun Ra Arkestra soundchecking next door.

4. Good lighting is also important. Soldering by candlelight = atmospheric, but not easy.

5. Tom Bugs has only been building electronics for five years - starting out with circuit bending. He's now at the point where he has an assitant to do the boring bits. He's a bit down on veroboard. He uses Eagle to design circuit boards, which are mass-produced in China. His next thing: modules for Frac-rac modular synths.

No comments:

Post a Comment